DuraTrel 11116 조립 지침 매뉴얼 - 페이지 3

{카테고리_이름} DuraTrel 11116에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DuraTrel 11116 6 페이지. 8' picnic table

TABLE TOP ASSEMBLY

Lay out five 96" table top rails (part 1 and 2) as shown above with pilot holes facing up. Table top rails have

two holes in the center of each rail, seat rails do not. Be sure wood inserts are flush with vinyl. Set two 25½"

table brackets (part 6) over pilot holes at each end of table top rail, leaving ⅛" gap between rails. Using twenty

¾" screws per bracket, fasten each bracket to table top rails.

Apply glue to inner edges of ⅞ x 1½" end cap (from hardware bag) and press on each end of 27" center brace

(part 8). Set center brace over pilot holes in center of table top. Using ten 1 ½"screws, fasten center brace to

table top.

Apply glue to inside edges of 28" table top end cap (part 10). Press end cap onto ends of table top (DO NOT

slide from end). Take care that end cap is flush with ends of table and use a file to round off any sharp edges.

8' Picnic Table