DAQ system EMB-OPT02 사용자 설명서 - 페이지 3

{카테고리_이름} DAQ system EMB-OPT02에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAQ system EMB-OPT02 15 페이지.

1. EMB-OPT02 소개

The EMB-OPT02 board converts the parallel (D0..D47) data signal of the J1 connector into an optical

signal and outputs it.

[Figure 1-1] shows an example of using the EMB-OPT02 board, which converts the image signal from

the CameraLink camera into light and transmits it to the PCIe-OPT02 board, which is the light receiving

board. 1 Base Camera Link configuration is supported.

[Figure 1-1. EMB-OPT02와 PCIe-OPT02 Connection]

Reference) The most important factor in selecting an optical cable is the communication distance.

A multimode cable provides a maximum transmission distance of 2Km, and a single-

mode cable basically provides a transmission distance depending on the type of

equipment. Communication using light basically uses 2Core. (RX-1 CORE, TX-1 CORE)

Therefore, be careful when connecting the board with a 2 core optical cable as shown

in the figure below.

EMB-OPT02 User's Manual