Duratuf Garrison PL63 조립 지침 매뉴얼 - 페이지 14

{카테고리_이름} Duratuf Garrison PL63에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf Garrison PL63 16 페이지.

SECURING SHED

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Garrison timber floor can then

be fitted on top of the Base Plate if required.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

FITTING A GARRISON FLOOR KIT (OPTIONAL)

• Position the Floor Joists centrally between the side Base

Plates and skew nail each end with two 75mm nails.

• Check that the shed is sitting level and square . Check

that the diagonal Bottom Plate measurements are the

same. This ensures that the shed base is square.

• Place the floor boards in position and nail securely

(6 x 50mm nails per board).

FIT PADBOLT

• Rivet Padbolt to door and keeper onto Door Jamb as

shown.

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS THOROUGHLY. FAILURE TO DO THIS

WILL RESULT IN CORROSION AND COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF GARRISON SHED IS NOW COMPLETE. RELAX......

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

BACK BASE PLATE

JOIST

FRONT BASE PLATE