Duratuf MK4A 조립 지침 매뉴얼 - 페이지 10

{카테고리_이름} Duratuf MK4A에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf MK4A 16 페이지. Kiwi series, base size 4.210mm x 2545mm

MK4A DOOR JAMB & CORNER FLASHINGS

Step 3: Fit Corner Flashing (101) over

corner Ribs with the top flush

with the top of the Top Plate.

Rivet in place with six rivets,

three each side. Repeat with

other three Corner Flashings.

When fitting Corner Flashings

on front wall, ensure they are

parallel with Door Jambs.

Note:

Condensation can form on the under side of shed roof. If building paper is required, fit now. Building paper will

need to be supported by netting or roofing twine.

Step 1: Check that the diagonal measurements of the shed are the same. If building on unlevel ground it may be neces-

sary to temporarily brace the shed with pieces of timber from the packaging.

Step 2: Position first Roof Sheet centrally over Ridge

Beam on the right hand end of shed with the

LIP on the left hand side. (For sheds with a

Clear Roof Panel, go to the next page). Posi-

tion the next Roof Sheet. Ensure it overlaps

correctly then rivet together, one rivet in the

centre and one 600mm down from the centre

on both sides. Fit remaining Roof Sheets.

Step 4: Centralize Roof at the other end and nail

through pan into Ridge Beam and Top

Plates. Ensure Ridge Beam is straight, then

nail one 40mm Weatherseal into Ridge Beam

beside each overlap (one nail per sheet). At

the back, set up a String Line in centre of

Top Plate. Ensure Top Plate is straight and

nail off, using one 40mm Weatherseal per

Pan. Repeat at the front.

MK4A ROOF

LIP

Step 3: Starting from the left hand end, centralise

Roof on Ridge Beam. Ensure Roof is tight

against end Wall Sheets and nail one 40mm

Weatherseal through Lip into the Ridge

Beam. At the back, line up Ribs on the Roof

Sheet with the Ribs on Wall Sheet. Using

one 40mm Weatherseal, nail through Lip into

Top Plate. Repeat at the front.