Duratuf PG96 조립 지침 매뉴얼 - 페이지 15

{카테고리_이름} Duratuf PG96에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf PG96 17 페이지. Base size: 3.020m x 2.020m

SECURING SHED

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Garrison timber floor can then

be fitted on top of the Base Plate if required.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

FITTING A GARRISON FLOOR KIT (OPTIONAL)

• Position the Floor Joists centrally between the side Base Plates

and skew nail each end with two 75mm nails.

• Check that the shed is sitting level and square . Check that the

diagonal Bottom Plate measurements are the same.

This ensures that the shed base is square.

• Place the Floor Boards in position. (You may need to cut the last

Floor Board to the correct width using a Skill Saw.) Nail each

Floor Board in, using two 50mm nails each end and two nails into

each floor joist.

FIT PADBOLT

• Rivet Padbolt to door and keeper onto Door Jamb as shown.

FIT BACK PADBOLT

•

Rivet back pad bolts to pad bolt supports then rivet pad bolt sup-

ports to back of small door (Top and bottom)

•

Using 10mm drill bit, drill hole into top and bottom timber plates

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS

THOROUGHLY. FAILURE TO DO THIS WILL RESULT IN CORROSION AND

COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF GARRISON SHED IS NOW COMPLETE. RELAX......

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

BACK BASE PLATE

JOIST

FRONT BASE PLATE