Duratuf Sentry Shed SL1507 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} Duratuf Sentry Shed SL1507에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf Sentry Shed SL1507 15 페이지.

SECURING SHED

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Sentry timber floor can then be

fitted on top of the Base Plate.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

OPTIONAL SENTRY FLOOR

• Position the Floor Joists centrally between the side

Base Plates and skew nail each end with two 75mm

nails.

• Check that the shed is sitting level and square and

that the diagonal Bottom Plate measurements are the

same.

• Place the Floor Boards in position. (You may need to

cut the last Floor Board to the correct width using a

Skill Saw.) Nail each Floor Board in, using two 50mm

nails each end and two nails into each floor joist.

FIT PADBOLT

• Rivet Padbolt to door and keeper onto Door Jamb as

shown.

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS THOROUGHLY. FAILURE TO DO THIS

WILL RESULT IN CORROSION AND COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF SENTRY SHED IS NOW COMPLETE. RELAX......

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

BACK BASE PLATE

JOIST

FRONT BASE PLATE