Duratuf SENTRY SHEDS SS1515 조립 지침 매뉴얼 - 페이지 8

{카테고리_이름} Duratuf SENTRY SHEDS SS1515에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf SENTRY SHEDS SS1515 15 페이지.

페이지 인쇄

ASSEMBLE SIDE PANELS

SELECT:

6 x 1850 Wall Sheets

2 x 1.520 Top Plates (Red)

2 x 1.520 Bottom Plates (Green)

72 x 30mm Galv Clouts

8 x Rivets

STEP 1:

 Lay out 1 x Top Plate and 1 x Bottom Plate on a flat surface as shown

(corner cutouts to face outwards).

Bottom plates are critical to ensure wall panels fit together.

STEP 2:

 Place 3 x 1.850 wall sheets on top of timber plates, with sheets

flush with each other.

 Rivet sheets together on overlaps as shown.

STEP 3:

 Nail wall sheets to the Top Plate at each end

making sure that the top of the sheets are flush with

the top of the Top Plate and the sides of the wall sheet

overhang the Top Plate by approx 15mm as shown.

 Check that the Top Plate is straight then nail

along the wall sheet to the Top Plate, two

clouts per pan (see fig. 1).

Std Shed — Bottom Plate will protrude below wall

sheet by approximately 10mm.

Raised base plate shed — Wall sheet will protrude

below the Bottom Plate by 20mm

STEP 4:

 Nail the wall sheets to the Bottom Plate at each end ensuring each

side of wall sheets overhangs the end of Bottom Plate by 15mm.

Check that the distance between the Top and Bottom Plates is

correct. (As per diagram in step 1)

 Check that the Bottom Plate is straight then nail the wall sheets to

the Bottom Plate, two clouts per pan (see fig. 1).

Repeat with second side panel ensuring Top Plate is positioned in

the OPPOSITE direction to the first side panel, as shown.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 5), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

Measurements between Top and

15mm

CLOUT

TIMBER PLATE

1810mm

15mm

RIB

PAN

fig.1

1810mm

15mm

1833mm

TOP PLATE

1833mm

BOTTOM PLATE

TOP PLATE

RIVET

BOTTOM PLATE

15mm

TOP PLATE

1833mm

BOTTOM PLATE

15mm

TOP PLATE

Second Side

1810mm

Panel

BOTTOM PLATE