Duratuf KIWI KL1 조립 지침 매뉴얼 - 페이지 11

{카테고리_이름} Duratuf KIWI KL1에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI KL1 16 페이지.

Note:

Condensation can form on the under side of shed roof. If building paper is required, fit now. Building paper

will need to be supported by netting or roofing twine.

Roof with Clear Panel: Handle Clear Panel with care. The Clear Panel will crack if not fitted correctly.

Riveting: Pre-drill 3.5mm hole through Clear Panel and Steel. Enlarge hole in Clear Panel with drill to allow

for expansion and contraction.

Screwing: Pre-drill a 6mm hole through the Clear panel.

Step 1: Check that the diagonal measurements of the shed are the same. If building on unlevel ground it may be

necessary to temporarily brace the shed with pieces of timber from the packaging.

Step 2: Position first Roof Sheet on the right

hand side of the shed with the LIP on

the left hand side. Position the next Roof

Sheet. Ensure it overlaps correctly

(when fitting a Clear Roof Panel, ensure

it OVERLAPS Roof Sheet). Rivet sheet

joins 500mm from edge, front and back.

Step 3: Position roof so that the front overhang

measures 140mm. Line up Ribs on the

Roof Sheets with Ribs on the Wall

Sheets. Ensure plates are straight then

screw roof to Top plates using one

50mm Roofing Screw on each Rib front

and back.

(Using 4 x 50mm galv clouts, nail clouts

on the outside ribs only, as these are

covered by the Barge flashing.

KL1 ROOF

50mm Clouts in

4 corners

Lip this side.

Pan

Rib