Duratuf KIWI KL1 조립 지침 매뉴얼 - 페이지 7

{카테고리_이름} Duratuf KIWI KL1에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI KL1 16 페이지.

Step 1: Front Wall: Position wall on the right hand side

of the doorway with the sheet LIP on the left

hand side. Ensuring the LIP is flush with the

side of the Stud and the top is 45mm below the

top of the Ridge Beam, tack in place.

Step 2: Back Wall: Position the first Wall Sheet with

the LIP on the right hand side. Ensuring the LIP

is flush with the side of the corner Stud and the

top of the Wall Sheet is flush with the top of the

Top Plate, tack in place. Position the next Wall

Sheet with the LIP on the right hand side. Over-

lap as shown in fig 1. Ensuring Wall Sheet is

flush with top of Top Plate, tack in place.

Step 3: End Walls: Position wall sheet with the LIP

flush with the side of the stud and the top of

the Wall Sheet is flush with the top of the Top

Plate, tack in place. Tack in remaining 1/2 Wall

Sheet. Repeat with the other end. If fitting a

window, nail in Window Studs and Nog now.

Refer to Window instructions.

Step 4: Nailing Off: Nail one 30mm Clout each side of the Rib (two per Pan) into the Top Plates and Bottom Plates. Nail

Wall Sheets to mid wall Nogs (one per pan). Nail each corner Wall Sheet to Studs using two 30mm Clouts evenly

spaced.

KL1 WALL CLADDING

EDGE

FLUSH

45mm BELOW

TOP OF RIDGE

BEAM