Duratuf KIWI SHEDS MK4A 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} Duratuf KIWI SHEDS MK4A에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratuf KIWI SHEDS MK4A 16 페이지. Base size 4.210mm x 2545mm

MK4A BARGE & SPOUTING

Step 1: Position Barge Flashing (A102) on gable

ends Position Spouting on the shed and

rivet to barge Flashing at each end. Repeat

with other Spouting.

Step 1: Place shed in final position. Check the diagonal

measurements are the same and the shed is

level before fitting Floor. It is recommended that

the shed is anchored down with either a Duratuf

Bolt Down Kit or Duratuf Peg Down Kit depend-

ing on what the shed is sited on.

Step 2:

Lay a Floor Board on top of Bottom Plates and Joist and

push up against end wall. Mark out where Studs are. Cut

checkouts with Electric Jigsaw so Floor Board will fit

around Studs.

Step 3: Re-position Floor Board. Lay out remaining Floor

Boards checking around Studs as you go. The

last Floor Board may have to be cut to size.

Step 2: Centralise Barge Flashing on gable end

MK4A FLOOR

and rivet in place, one rivet into every

second Rib. Fit two rivets through top of

Barge into Rib. Repeat with other Barge

Flashing. Check Spoutings are straight,

then rivet to Roof one rivet every second

Rib.