Darco Body Armor Walker II 지침 - 페이지 2
{카테고리_이름} Darco Body Armor Walker II에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Darco Body Armor Walker II 2 페이지.
페이지 인쇄
Instructions for use
Body Armor® Walker II
Lower leg walking cast replacement
1. Unlock all buckles and remove shin guard.
2. If off-loading for ulcers, fractures or other painful areas is desired,
remove bottom insole and modify it as described below.
3. Spread open the shell and lower the foot with the heel first into the
walker. A thick absorbent sock should be worn.
4. Place the shin guard into position and secure it under the edges
of the walker shell.
5. Insert straps into the buckles and adjust them to the desired
compression. Close the buckles to locked position.
Off-load site location
> Mark the area with a transferable marker such as lipstick or ink.
> Place the foot in the walker and stand to allow the mark to transfer to
the top insole.
> Use a straight pin (or similar object) to puncture through the centre of
the transferred mark. Important is the piercing of both layers.
> On the bottom of the lower insole, lightly mark the area to be removed,
as described in the diagram.
Off-loading modifications (A)
After accurately having located the area to be off-loaded on the lower
insole (see »off-load site location«), use a utility knife or drill to cut area
directly under the relief site. It is important to skive the edges (approx. 30°)
so that the opening away from the foot is slightly larger than the opening
on the upper surface. The relief area should be approximately 5 mm
larger than the outer edge of the area to be off-loaded and extend distally
12 mm (see diagram A). A hard, smooth-cutting surface (i. e. glass) is
recommended for more accurate and safe cutting results. In case of any
questions with regard to the product or how to attend to it please do not
hesitate to call our product specialists or send us an E-Mail.
1.
2.
3.
4.
5.
A
distal
12 mm
Ulzera
5
5
5