Addonics Technologies MST5HMXA 사용자 설명서 - 페이지 2

{카테고리_이름} Addonics Technologies MST5HMXA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies MST5HMXA 8 페이지. Mini storage tower

Note: You need to verify that the eSATA port you are connecting the tower is port

multiplier compatible. If it is connected to a non-port multiplier compatible host

controller, the operating system will only see one drive out of the five connected

and that is the drive connected to port 1.

For example, when the tower is connected to a SATA Host controller with SiI3124

or SiI3132 chip which is port multiplier compatible, in the RAID BIOS of the host

controller, you will only see one drive and that is the drive connected to port 1 on

the hardware PM.

All the SATA drives connected to the tower will show in the SATARAID5 Array

Manager of the SATA Host controller with SiI3124 or SiI3132 chip.

Removing Cover of Mini

Storage Tower

Loosen the 3 screws at the back of the tower

using a Philips screwdriver by turning

counter-clockwise.

Separate

the

metal

casing of the tower from the housing by lifting

up the casing as shown on the photo.

Installing drives into the

Storage Tower

Step 1

Slide the storage device into the embedded

mounting bracket.

Step 2

Using 3.5" SATA Hard Disk Drives

Connect the internal SATA data cable to the

data port of the hard drive then connect the

15-pin SATA power connector to the power

Hard Disk

port on the hard drive.

Step 3

Secure the hard disk by using screws

provided. Repeat the above procedure for

additional hard drives.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/