Contemporary Research ICC-PSC2 제품 설명서 - 페이지 6

{카테고리_이름} Contemporary Research ICC-PSC2에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Contemporary Research ICC-PSC2 18 페이지. Smart card controllers
Contemporary Research ICC-PSC2에 대해서도 마찬가지입니다: 사양 (2 페이지), 제품 보기 (2 페이지)

페이지 인쇄

Installation

Smart Card Installation

1. Turn off TV and remove the existing SmartCard cover plate, requires Torx T10 driver for screws

2. Install Philips Smart Card RF connections

a. ICC PSC – RF Out connects inside the TV Smart Card slot

i. Disconnect the attached RF cable from the tuner input below the card.

ii. Remove existing SmartCard slowly.

iii. Connect included RCA cable from the Cable/Antenna RCA to the RF Input on the bottom

iv. Connect the RCA cable from the card's RF Out to the TV's RF In connector inside the

b. ICC-PSC2 – RF Out connects outside the TV Smart Card slot

i. Attach included F to RCA adapter to the Cable/Antenna input on the PSC cover.

ii. Connect included RCA cable from the Cable/Antenna RCA to the RF Input on the bottom

iii. Connect the included RCA cable from the card's RF Out to the TV RF input, running the

3. Gently but fully insert PSC card into the Philips Smart Card slot.

4. Attach PSC cover plate to TV – for ICC-PSC2 cards, make sure the RF Out cable fits into the cable slot on

the cover plate.

5. Turn on TV.

6. The Net LED should light and stay on, indicating power, but not iC-Net communication.

7. Com LED turns on when data link with TV is established; LED blinks when data sent from IR remote,

front-panel buttons, or iC-Net commands.

RF Coax and iCC-Net Operation

1. Connect the CATV RF Coax cable into the Cable/Antenna jack.

2. If the iCC-Net signal is operating, the Net LED will blink once per second.

Note: Newer Philips TVs that use the ICC-PSC2 cards do not have an interior TV RF in connector, the ICC-PSC2

connects the RF Out to the TV's RF In connector on the outside of the TV, just below the card slot.

Contemporary Research Co

side of the card.

SmartCard port, located below the card slot.

side of the card.

cable outside to the TV's antenna input below the PSC2 card.

ICC-PSC Philips Smart Card