Addonics Technologies RR2035RPHES 사용자 설명서 - 페이지 4

{카테고리_이름} Addonics Technologies RR2035RPHES에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies RR2035RPHES 8 페이지. 5-port hpm-xa enclosure

Note: When the default factory RAID setting is used, independent drive configuration

and optical drive are supported only when connecting to controllers with Silicon

Image Sil3124, Sil3132 chip set or controllers that are Port Multiplier (PM)

compatible. Simultaneous DVD writing was tested using the Nero Burning Rom.

LED Pin Header

P4 P3 P2 P1 P0 P5

J1 – Drive Activity LED

P5 –

Activity LED for eSATA host port lights up when it is connected to a

SATA controller card.

P0, P1, P2, P3 & P4 - Activity LEDs for port 0, 1, 2, 3, 4 & 5 light up when a drive is

connected and blinks when there's drive activity.

J3 – Error LED

P5 –

error LED for eSATA host port

P0, P1, P2, P3 & P4 - error LED for port 0, 1, 2, 3, 4 & 5

Attach the SATA hard drives (up to 5) to the SATA ports on the Hardware

Port Multiplier (HPM) using SATA cables. It is recommended to connect

drives to the SATA ports 1 to 5 successively.

To provide power to the HPM, connect a 4-pin floppy power cable from the

system power supply to the floppy power connector on the HPM.

Optional: Connect LEDs to the Activity & Error LED jumper block

www.addonics.com

Error LED

Technical Support (M-F 8:30am - 6:00pm PST)

P4 P3 P2 P1 P0 P5

Phone: 408-453-6212

Email: www.addonics.com/support/query/