Addonics Technologies Z4RCS25NML 사용자 설명서 - 페이지 3
{카테고리_이름} Addonics Technologies Z4RCS25NML에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies Z4RCS25NML 4 페이지. Zebra disk array
페이지 인쇄Model: Z4RCS25HPM
Zebra Disk Array with integrated Hardware Port Multiplier -
The 4 drives in the Disk Array can be set up as RAID 0, 1, 10, Bigdrive, or as
individual drive via a PM compatible controller or USB port. Once configured as a
single RAID volume, the unit can be connected to any eSATA port or USB port.
USB port connection requires optional eSATA - USB connector.
Fan
Note: You need to install the SiI4726 Manager on your system to configure RAID
sets. Another requirement is a SATA drive needs to be connected to port 1 of the
hardware port multiplier.
RAID array is configured by connecting the hardware port multiplier:
•
to one of Addonics' SATA controllers that has SiI3124 or SiI3132 chip set.
•
via USB 2.0 connection (optional Addonics eSATA-USB adapter is required)
After RAID configuration, it is compatible with any SATA controller (RAID or non
RAID)
Software Installation for SiI4726 Manager
A.
From the CD start-up menu select SATA RAID Utilities > Other
SATARAID Utilities > Windows 2000/XP/2003/Vista.
B.
Unzip the file SiI_4726_Manager_V4.0.0.9.zip on your drive. The folder
name would be SiI4726.
C. To install SiI4726 Manager, double click setup.exe
In SiI4726 Manager, all the drives connected to the Zebra model will show up.
For a complete User's Guide of SiI4726 refer to our website.
Support > User Guides > SiI4726 Manager User Manual V.26
Switch
eSATA Port
Power
Connector
Model: Z4RCS25NML
Zebra Disk Array with integrated Multilane connector
The 4 drives in the Disk Array can be set up as RAID 0, 1, 5, 10, JBOD when
connected to a Multilane RAID controller.
Fan
Multilane connector
Note:
No drivers are necessary for the Multilane bridge. You should have
configured the Multilane SATA host controller by installing its driver and
utility before connecting the disk array.
Switch
Power
Connector