4B P3003V10AI 운영 매뉴얼 - 페이지 9

{카테고리_이름} 4B P3003V10AI에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4B P3003V10AI 16 페이지. Inductive proximity sensor

20 mm Diameter

Ferrous Target

Shaft

6mm

(Min)

Ensure all connections are correct before applying power. Apply power to the P300 and machinery, then

check that the output LED is flashing when the target is being sensed.

It is crucial that all exposed rotating shafts are provided with a full guard. Therefore, this device and its

target must be equipped with a guard.

Fasten the P300 to a suitable mounting bracket, such as 4B's Whirligig® universal shaft sensor mount,

with the nose of the switch within the sensing range of the target, as shown below -

Ferrous Target - 8 mm (5/16 in.) Max.

Non-Ferrous Target - 5 mm (3/16 in.) Max.

WARNING

P300 Shown on Optional Whirligig® Shaft Sensor

Mount with Mag-Con™ Magnetic Connector

PAGE 9