4B Touchswitch 운영 매뉴얼 - 페이지 12

{카테고리_이름} 4B Touchswitch에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4B Touchswitch 20 페이지. Belt misalignment sensor

TYPICAL MOUNTING POSITIONS ON A BUCKET ELEVATOR:

When mounting on the head section of a leg or belt conveyor try to catch the belt and the pulley. On a leg

mount Touchswitch™ just above the center line of the head shaft on the discharge side of the pulley when

possible. Sometimes this is not possible due to inspection doors or X-pacs etc. They can be mounted on

the top or up side of the head pulley if these are encountered. Try to mount Touchswitches so they are

accessible from the head section walkway.

TOUCHSWITCH™ MUST BE INSTALLED

ABOVE THE HEAD SHAFT BETWEEN THE 9

O'CLOCK AND 3 O'CLOCK POSITION ON THE

DISCHARGE (DOWN) SIDE OF THE LEG - IF

POSSIBLE.

NOTE: FOR INCREASED PROTECTION, MORE

TOUCHSWITCHES CAN BE ADDED TO THE

HEAD.

NOTE: MOUNT PAIR OF TOUCHSWITCHES

DIRECTLY ACROSS FROM EACH OTHER ON

RIGHT AND LEFT SIDE OF BUCKET ELEVATOR.

VIEW OF LEFT SIDE

MOUNT TOUCHSWITCH™ ON UPSIDE

OF LEG (IF POSSIBLE) AT THE HIGHEST

POINT THAT THE BOOTSHAFT CAN BE

ADJUSTED TO.

NOTE: FOR INCREASED PROTECTION,

MORE TOUCHSWITCHES CAN BE ADDED

TO THE BOOT.

PAGE 12