Addonics Technologies ADSAIDE44 설치 매뉴얼

{카테고리_이름} Addonics Technologies ADSAIDE44에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies ADSAIDE44 1 페이지.

Installation Guide

Front View

Master, Slave &

Cable Select

Jumpers

Jumper Settings

Master

Slave

Note:

To set the SATA hard drive as a Master Device

when connected to an IDE channel, you need to

short the top pins located on the converter by

placing a jumper. As a Slave Device short the

middle pins.

Locate the SATA connector of your 2.5" SATA drive.

ADDONICS TECHNOLOGIES

Model: ADSAIDE44

44-pin IDE Connector

SATA Power and

Data Connector

Pin 1 Marker

Cable Select

15-pin SATA Power &

7-pin Data Connector

Connect the converter board to the SATA connector of

the hard drive.

(Optional) Connect the IDE ribbon cable to the 44-pin

connector on the converter. The red edge of the ribbon

cable needs to line up to pin 1 marker of the 44-pin

connector. The other end of the ribbon cable will be

connected to your motherboard's 44-pin IDE channel.

TECHNICAL SUPPORT

Email:

http://www.addonics.com/sales/

Internet:

http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST)

Phone:

408 573-8580

Email:

http://www.addonics.com/support/ticketid/