Aplisens SGE-25C 사용자 설명서 - 페이지 15
{카테고리_이름} Aplisens SGE-25C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aplisens SGE-25C 20 페이지. Hydrostatic level probes
Aplisens SGE-25C에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)
페이지 인쇄
C
10.3. Spare Parts.
The following parts of the probe can be replaced when worn or damaged: cable, seals on the packing gland.
The cable may be replaced by the manufacturer only.
11. PACKING, STORAGE AND TRANSPORT
11.1. Packing, Transport.
The probes should be packed in such a way as to protect them from damage during transportation, in single or
multiple packs. The cable should be rolled into a loop
from moving relative to each other and the whole from moving within the package. Avoid breakage to the
cable at the point where it enters the packing gland. Packing should take place in closed rooms, where the air
temperature is not lower than +15° C, relative humid ity does not exceed 85%.
Land, sea or air transport may be used, provided that direct action of atmospheric effects is prevented.
11.2. Storage
The probes should be stored in multiple packs in covered rooms, free of vapours and reactive substances,
with an air temperature between +5° C and +40° C and relative humidity not greater than 85%.
12. GUARANTEE.
The manufacturer guarantees the proper functioning of the probes SGE-25.SMART, SGE-25S.SMART,
SGE-25, SGE-16, SGE-25C for a period of 24 months starting from the date of purchase (probe SGE-25S for a
period of 12 months), as well as servicing carried out under the guarantee and following the guarantee period.
13. ADDITIONAL INFORMATION
Related standards:
PN-EN 60529:2003
PN-EN61010-1
Ingress protection rating of casing (IP code)
Safety requirements for automated electrical measuring devices and
laboratory devices. General requirements.
13
≥
300 mm in diameter, secured so as to prevent the coils
DTR.SG...04
(ENG)