Aplisens SGE-25C 사용자 설명서 - 페이지 9

{카테고리_이름} Aplisens SGE-25C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aplisens SGE-25C 16 페이지. Hydrostatic level probes
Aplisens SGE-25C에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

INSTALLATION

6.1. General recommendation

The depth probes are installed in places where the liquid level is measured in wells, tanks, boreholes,

etc. The probe is immersed in the measured medium. A special cable extends above the medium

level and can be connected directly to the device cooperating with the probe or to the junction box.

The probe can be hung on the power cable, e.g. by using Aplisens SG cable hanger (item 1

in Fig. 1). In the event of frequent removal of the probe or when there is a risk of catching on

protruding elements during pulling up, it is recommended to hang the probe on a steel cord using

the carrying eye (item 2 in Fig. 1 - does not apply to SGE-16 probes).

Figure 1. Mounting brackets for probes.

The probe with an additional Teflon shielding on the cable should be hung on a carrying cable or

on an internal cable (do not grab the Teflon shield). Hang the probe in Ex version with the

grounding cord only by the lifting eye on an additional supporting wire.

Immediately before placing the SGE-25S or SGE-25C probe in the measured medium,

remove the protective cover from the probe separator. During installation, protect the

probe against mechanical shocks.

Figure 2. Probes diaphragm cover for SGE-25C and SGE-25S.

A special cable extends above the medium level and can be connected directly to the device

cooperating with the probe or to the junction box. If the probe is to be in the current or in the

turbulence area, it should be installed in a protective pipe, e.g. made of PVC.

Revision 01.A.001/2021.09

EN.IO.SGE