APLOS ANGEL 600 GPD 사용 설명서 - 페이지 7
{카테고리_이름} APLOS ANGEL 600 GPD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. APLOS ANGEL 600 GPD 9 페이지. Direct flow reverse osmosis drinking water system
페이지 인쇄Repair Guide
Failure description
Purified water
isn't coming
through the
system
Water leaks at
the connection
Purified water has
an unpleasant
taste or smell
Wastewater pipe
does not drain
Wastewater pipe
keeps draining
Water purifier
cannot be stopped
Loud sound of
RO system
Water purifier
starts frequently
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the environ
ment or human health from uncontrolled waste disposal, recycle it responsibly
to promote the sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact the retailer
where the product was purchased.
They can take this product for environmental safe recycling.
Possible Cause
Inlet valve is not open
CF Composite filter or
RO membrane blockage
Unit is not powered
Damaged connector
seal ring
Damaged filter cartridge
seal ring
The water purifier has not
been used for a long time
The water purifier was not
flushed as required when
it was installed Incorrect
tubing installation.
Inlet valve is not open
Filter blockage
Flush solenoid valve
blockage
Failure of one-way valve
Failure of inlet solenoid valve
Severe RO membrane
blockage
Failure of high-pressure
switchFailure of inlet
solenoid valve
Water pressure is lower
than 1.5 bar
The system is placed
against the cabinet.
Internal water pipe
interference
Composite filter blockage
Reversed installation of
check valve
Check valve missing
Failure of check valve
Troubleshooting
Open the water inlet valve
Replace the filter
Check the power under the sink, as this
mostly occurs when the power under the
sink is off. Also, check the connection
between the plug and the power outlet,
and ensure that the system has been
plugged correctly into the power outlet
Contact the seller for the replacement
spare parts
Drain at least 500 ml of water before
purified water usage
Re-Flush as required
Make sure the waste water tubing is not
connected with RO tap
Open the water inlet valve
Replace filter. If well water as the source
and the feed water has not been pre-treated,
the filter get clogged quickly. Ensure that
the feed water is pre-treated. Otherwise,
large particles in the well water will easily
clog the filter and shorten the filter life.
Contact the seller for the replacement spare
parts
Replace the filter
Contact the seller for the replacement spare
parts
Increase water inlet pressure. The sound will
decrease when the water pressure stabilizes
Do not place the system against the cabinet.
The system may vibrate when in operation
Adjust internal pipeline Replace the filter
Ensure proper installation of the check valve
06