4CR 6.5600.1000 운영 매뉴얼 - 페이지 5

{카테고리_이름} 4CR 6.5600.1000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4CR 6.5600.1000 7 페이지. Plastic welding kit

Kunststoff-Reparaturset

INTENDED USE

Plastic welding kit is intended for professional repair of plastic products and auto parts, e.g. repair of cracks, splits and deep

scratches on car bumpers, repair of car headlight fittings and etc. Moreover, the kit can be used for soldering metals and

electrical circuit boards.

SCOPE OF SUPPLY

Gas torch

Stainless steel mesh

Catalyst

Bars for welding ABS and PP plastics

Hot knife tip

Brush

Soldering tip

Hard plastic case

Metal rod

User's manual

TECHNICAL CHARACTERISTICS

Flame temperature

Hot air temperature

Tip temperature

Filling capacity

Operating time from one filling

Torch length (with catalyst without tip)

Torch weight (fully filled without tip)

1. REFUELING GAS

1.1. Use only high quality liquid Butane for refueling. Before refueling make sure that gas adjustment lever (8) is in "1" position

and «- GAS +»» switch is at «OFF» position.

1.2. Wait until the torch is cooled down naturally before refilling gas.

1.3. Hold the torch in an upside down position. Insert and press down butane container nozzle into the torch gas filling valve.

1.4. Stop filling when fuel sprays back indicating full inner container.

Note: Do not overfill the gas torch!

2. IGNITION SEQUENCE

2.1. Move the gas adjustment lever (8) from «1» to a position between «2 «and «3».

2.2. Holding the torch in one hand (the tip directed away from you) press the safety switch (children protection switch) with

the other hand and move the ignition button. The torch will start heating. If the torch is not heating repeat the procedure

specified above.

2.3. After ignition press and hold ignition button and simultaneously move the continuous flame button to the right to

«CONTINUOUS» position.

2.4. To turn off the torch move the continuous flame button to the left to "OFF" position and then move the gas adjustment

lever to "1". This will cut off the gas supply and extinguish the torch.

3. OPERATION

Plastic repair using stainless steel mesh:

3.1. Using a mini-sander with 120-180P abrasive, remove paintwork and primer from the area to be repaired and level down

the adjacent area. Sand the surface using fine abrasives.

3.2. Prepare the reinforcing steel mesh – using snips cut it into strips of the needed size about 12-25 mm wide.

3.3. Switch on the torch as described above in section 2 and wait while the torch gets heated. Adjust the flame using gas

adjustment lever (8) if necessary.

3.4. Be aware that the protective cover of the torch gets very hot during use and can cause serious burns if touched by bare

skin. Keep the heated torch parts away from flammable objects.

3.5. Be careful, do not overheat the plastics. Melt the mesh into the area to be repaired. To perform this procedure heat the

mesh and soften the plastic of the panel using the torch, then press the mesh into the plastic. As the melted plastic comes

through the mesh it can be smoothed over with the metal bar (included into the kit).

3.6. If the crack or damaged area is located on a curve of the panel, the stainless steel mesh can be formed to follow the

curve. The intention is to melt the mesh into the plastic and press it below the surface and then smoothen the surface with

a metal bar.

1300°C

600°C

210–400°C

17 ml

100 min. (at medium settings)

250 mm

115 g

Gebrauchsanweisung