APlusLift HW-10KOH 설치 및 운영 매뉴얼 - 페이지 10

{카테고리_이름} APlusLift HW-10KOH에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-10KOH 20 페이지. 2-post over head car lift 10,000lb capacity
APlusLift HW-10KOH에 대해서도 마찬가지입니다: 설치 매뉴얼 및 작동 지침 (17 페이지)

페이지 인쇄

Step 6 (Installing Swing Arms)

 Locate the 4 swing arms and swing arm pins. Take one of the arms and insert it over

the hole in the carriage torsion tube. Line up the holes and insert the pin. Repeat for

the three other arms.

Step 7 (Electrical Connection to Power Unit)

the wiring must comply with local code. Find a certified

 Warning:

electrician to connect the power unit to a power outlet. Protect each circuit

with a time delay fuse or circuit breaker.

 The car lift uses a 220V single phase power unit. The running amperage is 10A.

Recommend a 30A breaker and a 10-gauge wire.

 Yellow/Green is ground wire.

 For 220V single split phase with two hot wires, wire blue to Hot 1 and wire brown to

Hot 2.

 For 220V power from one hot and one neutral, wire blue to neutral and brown to hot.

 See the figure below for the reference.