APlusLift HW-10KOH 설치 및 운영 매뉴얼 - 페이지 14

{카테고리_이름} APlusLift HW-10KOH에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-10KOH 20 페이지. 2-post over head car lift 10,000lb capacity
APlusLift HW-10KOH에 대해서도 마찬가지입니다: 설치 매뉴얼 및 작동 지침 (17 페이지)

페이지 인쇄

Step 10 (Final Setup)

Hydraulic Fluid

 Remove the vent plug from the top of reservoir. You are going to fill the tank with fluid.

AW 32 or 46 Hydraulic oil is recommended. We do not recommend the transmission

fluid as it is too thin. The unit will hold approximately 2.64 gallons (10 liters) of fluid.

 If the arms go all the way to the top, hydraulic oil will flow to two cylinders. If the arms

go all the way to the bottom, hydraulic oil will flow back to the pump.

Check Assembly

 Check all bolts and nuts to make sure they are tight. Do not use an impact gun on

concrete Anchors.

 Check all fittings or leaks. If necessary, make sure the arm lock restraints are engaging

properly and smoothly. If not, tap the main lock forward or backward as needed with a

rubber mallet to insure proper engagement on all 4 gears with the arm restraint locks.

 Cycle lift up and down to insure carriages are synchronized.

Test & Adjust Lift

 With the power properly hooked up and hydraulic oil in the Pump Reservoir, push the

Push Button on the side of the Motor to raise the Carriages off the locks. Release the

Push Button and then pull the Lock Release Cable under each carriage to release the

locks. Run the lift all the way up and down two more times to bleed all the air from the

system.

 While running the lift, listen to safeties clicking. Each side should click simultaneously

or with-in a 1/2 second of each other. If they are not clicking together, then adjust the

cables to compensate by tightening the side opposite the one that is clicking last at the

cable bolt at the top of the carriage on the same side.

 Remember not to over tighten cables – they should be firm, much like a banjo string or

a fan belt in a car.

Bleed Air from Cylinders

 Place a vehicle on the lift and raise until swivel pads are contact with frame of the

vehicle. Raise the vehicle about 3 feet and then lower the vehicle until the tires touch

the floor. Keep raising and lowering the vehicle a few times and increase the height

each time until the vehicle completely reaches to the top. This procedure pumps all the

air from the system.

 Lifting speed will be faster (be normal speed) after air is bled out.

Please check Operation, Safety, and Maintenance before use.