APlusLift HW-8SXLT 설치 및 운영 매뉴얼 - 페이지 4

{카테고리_이름} APlusLift HW-8SXLT에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-8SXLT 19 페이지. 4-post portable storage car lift

READ THIS BEFORE INSTALLING THE LIFT! Improper installation can cause injury or

damage!

• Read this installation and operation manual in its entirety before attempting to install

the lift. Manufacturer or distributor assumes no responsibility for loss or damage of any

kind, expressed or implied, resulting from improper installation or use of this lift. Always

use professional installation companies.

• All persons using the equipment must be responsible, qualified, and carefully follow the

operation and safety guidelines contained in this manual.

• A level floor is required for proper lift installation and operation.

• DO NOT install this lift on any asphalt surface. Recommend on concrete surface a

minimum of 4" thick and 3,500 psi tensile strength with steel or fiber mesh

reinforcement.

• DO NOT install this lift over concrete expansion joints or cracks. (Check with your

building architect)

• DO NOT install this lift on an upper floor without written authorization from your

building architect. Should only be installed on a ground floor without a basement.

• DO NOT attempt to lift only part of a vehicle. This lift is intended to raise the entire

body of a vehicle only.

• NEVER lift any persons or vehicles containing persons. This lift is designed to lift

empty vehicles only.

• Rubber hammer

• Chalk line

• Sockets and open wrench set

• Ratchet driver

• Vise grips

• Tape measure

• Screwdrivers

• Torque wrench

• Two 10' to 12' step ladders

• 4' level

• 12" crescent wrench

• AW32 non-foaming hydraulic fluid (3-5 gallons)

Important Information

Recommended tools