APlusLift HW-10KBP 설치 및 운영 매뉴얼 - 페이지 14

{카테고리_이름} APlusLift HW-10KBP에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. APlusLift HW-10KBP 20 페이지. 2-post floor plate car lift 10,000lb capacity
APlusLift HW-10KBP에 대해서도 마찬가지입니다: 설치 매뉴얼 및 작동 지침 (16 페이지), 설치 및 운영 매뉴얼 (20 페이지)

페이지 인쇄
APlusLift HW-10KBP 설치 및 운영 매뉴얼
Only authorized personnel can operate the lift. Please read operating and safety
procedures carefully before operating the lift.
 Maintain and inspect lift in accordance with the owner's manual. Never exceed the
capacity.
 Do not operate a lift that is damaged or in need of repair.
 Allow only authorized persons in the lift area.
 Keep the lift area clear when raising or lowering the lift. NO RIDERS.
 Keep hands and feet away from pinch points at all times.
 Never override the lift's operating and safety controls.
 If a vehicle is suspected of falling, clear the area immediately.
 Do not rock the vehicle while positioned on the lift.
 Always use safety jack stands when installing or removing parts from a vehicle.
Vehicle Loading
 Position vehicle at the center of gravity between the pads. Make sure the vehicle is
neither front or rear heavy.
 Place pads at vehicle manufacturer's recommended pick up points. Make sure the
pads are in proper and safe positions to support the vehicle.
 Use caution before lifting pickup trucks, SUVs and other framed vehicles.
 Use truck adapters as needed. Never exceed 9" of pad height.
Raising Lift
 Push up switch to raise lift (make sure arm restraints engage or stop and slightly move
arm to allow gear to mesh) until tires clear the floor.
 Stop and check for secure contact on adapters and vehicle weight distribution. If
secure, raise to your desired height.
 ALWAYS lower the lift into the nearest lock position by pressing the lower lever to
relieve the hydraulic pressure and then let the latch set in a lock position.
 Never work under a lift when the lift is not in a locked position.
Lowering Lift
 Clear all obstacles under the lift to ensure that only the operator is near the lift area.
 Stay clear of lift and raise the lift off the safety locks by 2".
 Pull the safety latch which releases the cable ring one by one on each carriage and
press the lower lever to lower the lift.
 Unload the lift by first completely lowering the lift and then swinging the arms to drive
through position before moving the vehicle.

Operation

14