Abus Vitess 83 Insert 서비스 매뉴얼 - 페이지 12

{카테고리_이름} Abus Vitess 83 Insert에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Abus Vitess 83 Insert 20 페이지.

Abus Vitess 83 Insert 서비스 매뉴얼

ASSEMBLY INSTRUCTIONS - RIM

Delivery of the pre-loaded housing
Our pre-loaded housing includes all parts that are necessary to
assemble a functional cylinder
Inside the cylinder there is a black plastic plug which has to be
exchanged by a pinned core
The housing is filled corresponding to the factory standard with
steel springs and housing pins
Additionally the following parts are included: tailpiece, core
retaining clip
Step 1
Insert the cut key into the cylinder core
Place the profile check pin in the core
Step 4
Position the pinned core with the
inserted cut key and rotate the core to
the 2 o'clock position
Step 7
Insert the tailpiece into the core and
push on the core retaining clip
12
Step 2
Insert the hardened InTop pin into the 1st
chamber
Attention: Pull the key a little and insert
it again
Step 5
Push the core inside until the plastic
plug has been pushed through
completely
Rotate the core forward clockwise until
the key is at the 12 o'clock position
Step 3
Insert the bottom pins made of hardened
steel into the 3rd chamber
Insert the bottom pins made of nickel silver
into the 2nd and 4th to 6th chamber
Only for master keyed systems: Insert master
wafers
Check with cut key – no pin should be
positioned too low or above the shear line
of the core – control with assembly tool
possible
Step 6
Remove the key by holding the core with
your thumb
The core isn't fixed yet and could be
pulled out with key inside