APOCALYPSE APOC01 사용자 설명서 - 페이지 2

{카테고리_이름} APOCALYPSE APOC01에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. APOCALYPSE APOC01 5 페이지.

페이지 인쇄

1. Safety Instruction

Please read the instruction carefully which including important

information about the installation, operation and maintenance.

WARNING

♦ Please keep this User Manual for future consultation. If you sell the unit to another user,

be sure that they also receive this instruction booklet.

♦ Unpack and check carefully there is no transportation damage before using the unit.

♦ Before operating, ensure that the voltage and frequency of power supply match the power

requirements of the unit.

♦ It's important to ground the yellow/green conductor to earth in order to avoid electric

shock.

♦ The unit is for indoor use only and use only in a dry location.

♦ The unit must be installed in a location with adequate ventilation, at least 50cm from

adjacent surfaces. Be sure that no ventilation slots are blocked.

♦ Disconnect mains power before fuse/lamp replacement or servicing.

♦ Replace fuse/lamp only with the same type.

♦ Make sure there are not flammable materials close to the unit while operating as it is fire

hazard.

♦ Use safety cable when fixes this unit.

♦ Maximum ambient temperature is TA: 40℃ and don't operate it where the temperature is

higher than this.

♦ Unit surface temperature may reach up to 60℃. Don't touch the housing bare-hand during

its operation. Turn the power off and wait for 15 minutes for cool down before replacing

bulb or serving.

♦ In the event of serious operating problem, stop using the unit immediately. Never try to

repair the unit by yourself. Repair carried out by unskilled people can lead to damage or

malfunction. Please contact the nearest authorized technical assistance center and

always use the same type spare parts.

♦ Don't connect the device to any dimmer pack or power pack.

♦ Do not touch any wire during operation as high voltage might be causing electric shock.

2. Technical Specification

• Voltage: AC 100V/120V/230V/240V/250V 50/60Hz

• Lamp: MSD 250W

• 2 Channels

Channel 1 = Rotation

Channel 2 = Lamp

• It can be operated by DMX512 control or can be used as an individual unit without

controller.

• It can be linked together as many as required in master/slave mode, and perform the great

built-in programmed lighting shows triggered by music.

• Please use a 3 pin XLR cable/plug when connecting them together.

• It features different pre-programmed chase patterns.

• Fan cooled.

• Dimension: 374 x 312 x 298 mm

• Weight: 10.6 kg

3. Installation

You can install the unit on the truss or ceiling, Use

clamps to fix the unit to truss. Always ensure that the

unit is firmly fixed to avoid vibration and slipping while

operating. Always ensure that the structure to which

you are attaching the unit is secure and is able to

support a weight of 10 kgs for each unit. Also always

use a safety cable that can hold 10 times of the weight

of the unit when installing the fixture.