Addonics Technologies Z4SN25NML 사용자 설명서 - 페이지 2

{카테고리_이름} Addonics Technologies Z4SN25NML에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies Z4SN25NML 2 페이지. Z snap-in disk array

Installation

1. Connect the AC power adapter's input to a wall outlet

and the output cable to the Z Disk Array's power connector.

2. Connect the Multilane connector to the computer

using an Infiniband cable.

3. Turn on the unit using the power switch on the back

next to the power connector (see note).

Front

Key locks to

lock drive door

LEDs for

drive activity

Back

Multilane Port

www.addonics.com

Power Switch

Power

Connector

Technical Support (M-F 8:30am - 6:00pm PST)

Disk Installation

1. Be sure the lock on each drive door is

unlocked. If not, use the key that came

with the Z Snap-In Disk Array to unlock the drive door. Pull

on the door lever to swing open the drive door all

the way.

2. Slide a 2.5" SATA hard drive into the drive slot

with the drive connector side facing in and the label

side up. The drive should slide all the way into

the slot with very little resistance. Forcing the

drive into the slot will cause permanent damage

to the drive or the Snap-In enclosure.

3. Once the drive is all the way into the drive slot,

close the door all the way till the drive door latches

securely. This will engage power and data

connection with the hard drive. You may lock the

drive door with the key.

4. To remove the hard drive from the enclosure,

simply follow the step 2 – 3 in reverse.

Note: Hot swapping the drives must be supported

by the host adapter. Powering the cabinet on or off

or inserting or removing drives when connected

to a host adapter that does not support hot swapping

will cause undesirable results.

Phone: 408-453-6212

Email: www.addonics.com/support/query/