Apogee SQ-100 Series 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Apogee SQ-100 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee SQ-100 Series 17 페이지. Quantum sensor
Apogee SQ-100 Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (2 페이지)

페이지 인쇄

OPERATION AND MEASUREMENT

Connect the sensor to a measurement device (meter, datalogger, controller) capable of measuring and

displaying or recording a millivolt signal (an input measurement range of approximately 0-500 mV is

required to cover the entire range of PPF from the sun). In order to maximize measurement resolution

and signal-to-noise ratio, the input range of the measurement device should closely match the output

range of the quantum sensor. DO NOT connect the sensor to a power source. The sensor is self-

powered and applying voltage will damage the sensor.

All Apogee un-amplified quantum sensor models (SQ-100 and SQ-300 series) have a standard PPF

calibration factor of exactly:

Multiply this calibration factor by the measured mV signal to convert sensor output to PPF in units of µmol

-2

-1

Calibration Factor (5.0 µmol m

5.0

5.0 µmol m

-2

-1

per mV) * Sensor Output Signal (mV) = PPF (µmol m

Example of PPF measurement with an Apogee quantum

sensor. Full sunlight yields a PPF on a horizontal plane at

the Earth's surface of approximately 2000 µmol m

yields an output signal of 400 mV. The signal is converted to

PPF by multiplying by the calibration factor of 5.00 µmol m

-1

per mV.

-1

per mV

400

-2

-1

)

2000

-2

-1

. This

-2