Apogee SQ-618 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Apogee SQ-618에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee SQ-618 19 페이지. Epar sensor
페이지 인쇄
38
39
Integer Registers
48
49
50
51
52
53
54
55
56
57
58
59
*Registers marked with an asterisk (*) cannot be written to unless a specific procedure is followed. Contact
Apogee Instruments to receive the procedure for writing these registers
Write only registers (function code 0x10).
Integer Registers
baudrate (0 = 115200, 1 = 57600, 2 = 38400, 3 = 19200, 4 = 9600, any other
190
heater status
slave address
model number*
serial number*
number = 19200)
parity (0 = none, 1 = odd, 2 = even)
number of stopbits
multiplier (shifted two decimal points to the left)*
offset (shifted two decimal points to the left)*
immersion factor (shifted two decimal points to the left)*
solar multiplier (shifted two decimal points to the left)*
running average
heater status
Writing to this register resets Coefficients to firmware
defaults. (NOT factory calibrated values!) Slave Address =
1, Model = 618, Serial = 1000, Baud = 3, Parity = 2, Stopbits
= 1, running average = 1