Apogee Symphony Mk II 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Apogee Symphony Mk II에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Symphony Mk II 17 페이지.

Connecting inputs

1. Connect an 8 channel DB25 breakout cable (not included)

to Analog IN on the lower I/O Module (Module Slot1) and

plug in the desired input source.

2. On the front panel touchscreen, tap the INPUT icon to

navigate to the INPUT page.

3. Select the corresponding input channel then tap the

Analog Level button to select the desired level +4dB,

-10dB or Mic if you have an 8 channel mic preamp module

installed.

4. To adjust the line input trim, press the Show Trim button

and tap the trim focus ring to enable the control knob. If

you have an 8 channel mic preamp module installed tap

the gain focus ring to enable the control knob and adjust

the mic pre gain.

| Symphony I/O Quick Start Guide

To route audio from general audio applications such as

iTunes and Safari through Symphony I/O Mk II, you must

set up Symphony I/O Mk II as the default output device in

Mac System Preferences.

NOTE: Make sure you have already installed the most

recent Symphony I/O Mk II Software from the Apogee

website before proceeding.

1. Click the  icon in the upper-left corner of your

Mac's display.

2. From the drop-down menu,

select "System Preferences..."

3. In the System Preferences control panel,

select "Sound"

4. At the top of the Sound Preferences panel,

select the "Output" tab

5. Under "Select a device for sound output:"

click Symphony I/O Thunderbolt

Now sound from iTunes or Safari can be played

through Symphony I/O Mk II's default outputs.

Outputs un-muted

Outputs muted

If you do not hear sound verify the output has

not been muted by looking at the M icon below

the headphone or speaker icon on the HOME

screen. To un-mute headphones or speakers,

simply press the control knob with the desired

output selected.

Symphony I/O Quick Start Guide |