Apogee SP-212 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Apogee SP-212에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee SP-212 18 페이지. Pyranometer
Apogee SP-212에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지)

OPERATION AND MEASUREMENT

Connect the sensor to a measurement device (meter, datalogger, controller) capable of measuring and displaying or

recording a millivolt (mV) signal (an input measurement range of approximately 0-250 mV is required to cover the entire

range of total shortwave radiation from the sun). In order to maximize measurement resolution and signal-to-noise ratio, the

input range of the measurement device should closely match the output range of the pyranometer.

SP-110: The sensor is self-powered and applying voltage will damage the sensor.

VERY IMPORTANT:

Apogee changed all wiring colors of our bare-lead sensors in March 2018 in conjunction

with the release of inline cable connectors on some sensors. To ensure proper connection to your data device,

please note your serial number or if your sensor has a stainless-steel connector 30 cm from the sensor head then

use the appropriate wiring configuration below.

Wiring for SP-110 Serial Numbers range 0-60050

Wiring for SP-110 Serial Numbers 60051 and above or with a cable connector

Red: Positive (signal from sensor)

Black: Negative (signal from sensor)

Clear: Shield/Ground

Black: Negative (signal from sensor)

Clear: Shield/Ground

White: Positive (signal from sensor)