Apogee SS-110 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Apogee SS-110에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee SS-110 20 페이지. Spectroradiometer

SOFTWARE INSTALLATION

Install Apogee Spectrovision software: Double click the

setup.exe file provided on the thumb drive (you may need to

copy the file to your computer first). Run the downloaded

setup file, following the prompts to complete software

installation.

*Note: In the final setup window there will be a box checked that says

"Launch Driver Installation". This box must be checked.

Install Drivers: You will be automatically prompted to install device

software drivers (dpinst.exe). Click next to begin the installation

process and follow the prompts.

Plug sensor into computer *Note: It may take up to 30 seconds for the computer to recognize the device each

time it is plugged into the computer.

Wait for 30-60 seconds while drivers associate with the device. This will happen automatically.

Open Apogee Spectrovision Software

Connect Sensor: In the "File Menu" click "Connect" to connect sensor. Sensor will

now be visible in the "Tool Bar" and is ready for use.

All of the available software buttons and controls are documented in the "Help

Menu", where information regarding uses and limitations of each button/control is

provided.

**Note** Windows XP users may need to install additional language options for some of the characters to display properly in

Apogee Spectrovision. To do this go to Control Panel->Regional and Language Options. Click the Languages tab. In the box

labeled supplemental language support, install both options. The software doesn't care if these are installed or not; it's simply

user preference.

(REQUIRED TO USE WITH A COMPUTER)