Apogee AD-8000 애플리케이션 노트

{카테고리_이름} Apogee AD-8000에 대한 애플리케이션 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee AD-8000 2 페이지. When i feed the ad-8000 a 20- or 24-bit signal from some of my gear, the 16/20/24 resolution indicators do not read the correct word length (number of bits). why is this?
Apogee AD-8000에 대해서도 마찬가지입니다: 데이터시트 (1 페이지), 애플리케이션 노트 (2 페이지), 애플리케이션 노트 (1 페이지)

페이지 인쇄

Application Notes

The best way to synchronize your 2" machine to an AD-8000 is to use a synchronizer to act as

master over the 2" transport. In this application note we will discuss the most popular

synchronizers, the Timeline Lynx systems (Lynx I, Lynx II, and Micro Lynx).

Lynx and Lynx II

2" ATR

TRANSPORT

from tape

CONTROL

LYNX firmware v. 5.0 or higher

LYNX II any firmware version

The idea is to have the Lynx control the 2" transport. The time code from tape is fed into the

Lynx. The TC is then regenerated (referenced to the Lynx's internal crystal) and output to the

USD. The USD is consequently always receiving fresh TC referenced to a stable crystal source

(the same source that is controlling the ATR transport). Your digital audio won't suffer from the

inconsistency in speed (wow and flutter) of a "wild" analog tape recorder.

Lynx Setup (the Lynx must have firmware version 5.0 or higher)

DSPL SEL

GEN

CODE TYPE

for 29.97 non-drop (which is what you should be using) choose NTSC

REF SRC

INT XTL (or VIDEO if using Black Burst as master sync)

GEN MODE

TACH>TC

GEN ON

switch to ON

DSPL SEL

READER

1999 Apogee Electronics Corp

Topic: Analog Tape Recorder/Time Line Synchronizers/PT

SYNC SOURCE: WC

(when using Slave

Clock select AMBus

slot w/ Digi-8+ card)

CLOCK REF: LTC

GEN

POSITION REF: LTC

OUT

AD-8000/ATR/Lynx

PRO TOOLS

DIGI-8+

MULTIPIN

CABLE

APOGEE AD-8000

(or Slave Clock)

UNIVERSAL SLAVE DRIVER

(for SSD or VSD use SLAVE CLOCK)

Product: AD-8000

Document #: 14

Page 1 of 2