Apogee BIG BEN 매뉴얼 사용
{카테고리_이름} Apogee BIG BEN에 대한 매뉴얼 사용을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee BIG BEN 3 페이지. Using big ben with pro tools; using the big ben with a sync i/o
Apogee BIG BEN에 대해서도 마찬가지입니다: 데이터시트 (2 페이지)
페이지 인쇄APOGEE Connects:
On this fi rst page we will deal with connecting Big Ben to a Pro Tools HD rig without using a Sync I/O.
The next page deals with connecting with the Sync I/O.
1) Connect a 75 ohm BNC cable between the WC Out connections of Big Ben and the EXT In of each
audio interface. (as shown below)
2) Do NOT connect the LOOP Sync connections between the audio interfaces. To best take advantage of
Big Ben's superior clock, each interface must be connected directly to a Big Ben word clock output.
1) Determine the desired sample rate for
the entire HD system, and set Big Ben
to that Sample rate.
2) In Pro Tools software, Session>Setup>
Click on the "Clock Source" fi eld, select
the fi rst audio interface, and set its clock
source to "Word Clock"
3) Repeat Step 2 for all audio interfaces.
Note that selections made for previous
interfaces will not be checked; this is
normal.
4) Verify on the front panel of each audio
interface that Sync Mode is set to EXT.
Using Big Ben with Pro Tools (without a Sync I/O)
Send a separate W/C Out of
the Big Ben to the W/C In on
each interface. Once again,
Do NOT use Loop Sync!