Apogee X-Video Card 사용자 설명서 - 페이지 8

{카테고리_이름} Apogee X-Video Card에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee X-Video Card 9 페이지. X-series expansion cards
Apogee X-Video Card에 대해서도 마찬가지입니다: 데이터시트 (1 페이지)

페이지 인쇄

X-Video – User's Guide

Installing the X-Video card

Plastic standoff here

Your X-Video card should include the following:

1 X-Video circuit board

1 X-Video Coverplate

2 aluminium standoffs

1 plastic standoff

1 manual

1 Remove the top cover of Big Ben.

2 Remove the Option Card coverplate, and set aside the screws for

later use.

3 Remove the two interface circuit board screws indicated at left, and

set them aside for later use

4 Install the two aluminium standoffs in the threaded holes vacated

by the screws.

5 On the X-Video card, install the plastic standoff in the hole adjacent

to the multi-pin motherboard connector.

6 Install the X-Video Coverplate, and secure it to the host interface

using two screws from Step 2.

7 Insert the BNC connector end of the X-Video card through the ap-

propriate cutouts in the coverplate, and carefully place the multi-pin

motherboard connector in the mating connector found on the host

interface motherboard.

8 After verifying the alignment of the multi-pin and the mating con-

nectors, ﬁrmly press down on the X-Video card, over the connector,

until the pins are completely seated in the mating connector.

9 Re-install the circuit board screws from Step 3 in the locations

indicated below.

10 Replace the top cover of Big Ben.