Apogee 05009 사용 설명서 - 페이지 5

{카테고리_이름} Apogee 05009에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee 05009 6 페이지. Two-stage altitude rocket for altimeters

페이지 인쇄

Prepping for Launch

If you are using the PerfectFlite FireFly

altimeter, you'll need the long payload tube.

If you're using either the MicroPeak or the

Adrel altimeter, you can place the altimeter

directly into the nose cone. If you do that,

drill a small hole into the plastic transition

section to allow air in for the altimeter's pres-

sure sensor.

Place the nose on top, and secure it in

place with a piece of tape wrapped around

the perimeter.

Launch Supplies Needed

To launch your rocket you will need the

following supplies:

• A model rocket launching system

• Flame resistant recovery wadding

• Recommended Rocket Engines:

See the motor matrix to the right.

Rocket Preflight

A. Crumple and insert a sheet of recov-

ery wadding into the body tube.

B. Roll the streamer and insert it into the

tube with the shock cord. Then install the

payload bay or nose cone.

C. Tape the nose cone onto the payload

tube (illustrations top-right on this page).

D. If flying the sustainer stage alone as

a single stage, it is preferable to hold the

engine in the tube by wrapping tape about

the portion of the motor that extends out the

rear of the tube as shown.

E. If you're flying the Spek as a two-stage

rocket, the motor in the top stage is friction

fitted into the tube.

Drill small hole

Spek Rocket Recommended Motors

Engine

Manufacturer

1/4A3-3T

Estes

1/2A3-4T

Estes

A10-3T

Estes

A3-4T

Estes

A10-0T / A3-4T

Estes

A & B

Motor Retention for

when the sustainer is

flown alone (without

the booster stage)

Tape

Altitude (ft)

133

341

682

733

1206

Tape

Motor Retention for when the

sustainer is flown with the

booster stage

Altitude (m)

40.7

104.1

208.0

223.5

367.7

Page 5