Apogee 10545 사용 설명서 - 페이지 3
{카테고리_이름} Apogee 10545에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee 10545 8 페이지. 1.9" ebay kit for aerotech rockets
페이지 인쇄Apogee 1.9" Ebay Assembly Instructions
Rocket Tube Preparation/Sled
Assembly
1. Mark your tube coupler in the middle with
a pen or pencil. Insert the coupler into the main
parachute bay tube up to the line and tape it to
hold it into place.
2. Cut out the "Paper Wrap Marking Guide"
from the "Detailed Parts Sheet/Checklist" page
of this instruction manual. Wrap the guide
around the back end of the main parachute bay
tube and tape it into place.
3. Carefully drill holes through both tubes
using the marked areas on the guide.
*Once you're finished and you've removed the
guide, cleanly sand the cardboard fuzz away
from the holes. Apply a small amount of thin
super glue to the recently drilled holes. Allow
the glue to dry and then gently sand off any
excess glue. This will help clean up the edges
and strengthen the holes you made.
4. Mark the wood parts with a pencil (ex-
cept the sled "E" for now) using the example
image to the right. *They are already etched
on the plywood sheet but marking the shapes
themselves with a pencil will serve as a helpful
reference during the assembly process.
5. Remove the sled Shape "E", the 2 disks
"B1 & B2" and Shape "C" from their plywood
sheets. Leave the other pieces in for now. Re-
move the small excess pieces inside the slots &
holes with a pencil or screwdriver.
6. Gently sand both sides of the sled and
test fit one of the "B" disks on each end. The
disk should slide on and off easily on both ends
when completed. Now mark the ends of the
sled with a pencil as "E1 & E2". Use the image
example in Step 4.
7. Sand the sides of Shape "C" and then
place it into the slot on the sled. Make sure
the wider end sticks up from the side of the
sled that shows the Apogee logo imprint. Once
securely in place, dab a small amount of wood
glue on the joining pieces along the non-
Apogee side and let dry.
8. Insert Metal Weld Nuts "H" into Shape
"C" with male ends facing outwards towards
Apogee logo imprint. Apply thick super glue to
the weld nuts to secure them into place. *Be
careful not to get super glue in the threads.
Also, you can center the weld nuts by placing
the A1 piece on the end while gluing the them
into place.
Step 1
Tape
Tube coupler
sticking out
Aligning
marks
Make sure the marking guide
is aligned with end of tube
Step 2
"A2" Shape (larger disk)
B2
A2
"B2" Shape (larger disk)
"B1" Shape (smaller disk)
B1
A1
"A1" Shape (smaller disk)
"C" Shape
"D" Shapes
Sand
surfaces
rst
Step 7
Top Side of Sled
Step 8
Side View
The end of this tube
Tube coupler
Step 3
"E2" side
E2
"E" Shape
E1
Step 4
"E1" side
Wider side on top
Wood glue
goes here
Side View
Page 3
Side View