Apogee Atomizer 05054 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Apogee Atomizer 05054에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Atomizer 05054 8 페이지.

Misfire Procedure

Occasionally the igniter will burn, but the motor will fail to ignite. If this happens, the cause is that the pyrogen on the igniter

was not in contact with the engine's propellant. When an ignition failure occurs, remove the safety key from the launch

controller and wait 60 seconds before approaching the rocket. Remove the old igniter from the engine and install a new

one. Make sure that the igniter is inserted fully into the engine and touches the propellant. Secure the igniter as directed on

the engine package and repeat the countdown and launch procedure. Always follow the NAR* Model Rocket Safety Code

when launching model rockets.

*National Association of Rocketry **Kevlar® is a brand name of E.I. DuPont for their selection of aramid fibers. Only DuPont makes Kevlar®.

Need parts or Accessories to go along with this kit?

Go online and order at www.ApogeeRockets.com or call us and

order at 719-535-9335. We're available M-F: 9:00am-5:00pm MST

Page 8