Apogee Black Brant VC 매뉴얼 - 페이지 8

{카테고리_이름} Apogee Black Brant VC에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Black Brant VC 16 페이지.

30. Apply thin CyA adhesive to the upper edges of

the cardstock details. Allow the CyA adhesive to

harden. Then gently sand down the surface of the

details using a fine grit sandpaper to smooth all

the edges.

Canards:

31. Using a sharp hobby knife, cut out the four

canards (part "C") and four of the pivot plates (part

"D") from the cardstock detail sheet (one extra piv-

ot plate is provided on the sheet). Sand the edges

as required to remove the remnants of the tabs.

32. Apply wood glue to the bottom and tab of the

canard (part "C"). Insert the "C" piece tab into the

"D" part. Due to the small size of the pieces, it can

be easier to apply the glue using a toothpick rather

than directly from the bottle. Carefully adjust the

two parts of each assembly so that they join at a

right angle and allow the canard assemblies to dry.

Repeat for the remaining three canard fins.

33. Apply thin CyA to each of the exposed edges

of the canards and allow the adhesive to harden.

Once the adhesive has set up, smooth the edges

of the parts with fine sandpaper.

Scale Rail Guides:

34. Using a sharp hobby knife, cut out two of the

"G" parts (three are provided) and one "H" part

(two are provided) from the 3/32" balsa sheet.

Page 8

Step 30

Step 31

Step 32

Step 33

Step 34