Apogee Skill Level 4 매뉴얼 - 페이지 3
{카테고리_이름} Apogee Skill Level 4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Skill Level 4 16 페이지.
5. Pass the shock cord through the second
notched ring. Using wood glue, place a ring of glue
around the outer forward edge of the tube and
slide the second ring over the tube, flush with the
end of the motor mount tube. Pull the shock cord
tightly against this newly installed ring, and apply a
generous fillet of wood glue over the whole sur-
face of the shock cord loop by applying a bead of
glue to the joint and forming it into a fillet with the
tip of a finger.
6. Apply wood glue to the inside of the forward
end of the motor mount tube and insert the small
blue CR-13/18 engine block ring so that it presses
against the engine hook. The ring should be inset
1/4" (6mm) from the forward end of the motor
mount tube.
7. Apply glue to the outer aft end of the motor
mount tube and slide the modified "C" ring (as cut
in Step 1) over the tube, so that the motor hook
passes through the slot and the ring is flush with
the aft end of the tube. Apply a fillet to this aft ring
but DO NOT GLUE THE MOTOR HOOK DOWN.
Allow the motor mount assembly to dry enough
that the joints are solid before continuing.
8. Using a pencil, mark the 24mm diameter (3-
3/4" or 95mm long) tube at a point 1-9/16" (40mm)
from one end. The end that was measured from is
the aft end of the tube.
9. Taking the motor mount assembly completed
in Step 7, route the shock cord through the center
of the motor mount tube so that it hangs out the
back. Then, apply a ring of glue around the inside
edge of the aft end of the 24mm tube marked in
the last step. Insert the motor mount assembly,
sliding it through the glue and into the tube fully,
so that the aft ends of the tubes are flush with one
another.
Step 5
Step 6
Step 7
Step 8
1-9/16" (40mm)
Aft
Step 9
1/4"
(6mm)
Do Not
Glue Hook
Flush with Aft End
of Tube
Page 3