4D systems gen4-uLCD-24PT 시작하기 매뉴얼 - 페이지 8

{카테고리_이름} 4D systems gen4-uLCD-24PT에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4D systems gen4-uLCD-24PT 20 페이지. Intelligent display modules

Option C – Using the 4D-UPA

1. Connect one end of the FFC to your module's 30 way ZIF socket with

the metal contacts on the FFC facing up on the latch.

2. Connect the other end of the FFC to the 30-way ZIF socket on the 4D-

UPA with the metal contacts on the FFC facing up on the latch.

3. Connect the USB-Micro-B Cable to the 4D-UPA.

4. Lastly, connect the other end of the USB-Micro-B Cable to the

computer.

After following the appropriate set of instructions in the previous section,

you now need to configure and setup Workshop4 to make sure that it

identifies and connects to the correct display module.

1. Open Workshop4 IDE and create a new project.

2. Select the display module you're using from the list.

3. Select your desired orientation for your project.

4. Click next.

5. Choose a WS4 Programming Environment. Only the compatible

programming environment for the display module will be enabled.

gen4-uLCD-XXPT - GETTING STARTED MANUAL