Apogee Instruments SQ-612 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Apogee Instruments SQ-612에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Instruments SQ-612 18 페이지. Epar sensor
Apogee Instruments SQ-612에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지)

페이지 인쇄

TROUBLESHOOTING AND CUSTOMER SUPPORT

Independent Verification of Functionality

Apogee SQ-612 and SQ-615 ePAR Sensors provide an amplified voltage output that is proportional to incident

photon flux density for the 400-750 nm wavelength range. A quick and easy check of sensor functionality can be

determined using a DC power supply and a voltmeter. Power the sensor with a DC voltage by connecting the

positive voltage signal to the red wire from the sensor and the negative (or common) to the black wire from the

sensor. Use the voltmeter to measure across the white wire (signal output) and black wire (signal ground). Direct

the sensor head toward a light source and verify the sensor provides a signal. Increase and decrease the distance

from the sensor head to the light source to verify that the signal changes proportionally (decreasing signal with

increasing distance and increasing signal with decreasing distance). Blocking all radiation from the sensor should

force the sensor signal to zero.

Compatible Measurement Devices (Dataloggers/Controllers/Meters)

-2

-1

SQ-600 ePAR Sensors are calibrated with a standard calibration factor of 1.6 µmol m

per mV (SQ-612) or 0.8

-2

-1

-2

-1

-2

-1

µmol m

per mV (SQ-615), yielding a sensitivity of 0.6 mV per µmol m

(SQ-612) or 1.3 mV per µmol m

(SQ-615). Thus, a compatible measurement device (e.g., datalogger or controller) should have resolution of at least

-2

-1

0.6 mV (SQ-612) or 1.3 mV (SQ-615) in order to provide photon flux density resolution of 1 µmol m

An example datalogger program for Campbell Scientific dataloggers can be found on the Apogee webpage at

https://www.apogeeinstruments.com/downloads/#datalogger.

Cable Length

When the sensor is connected to a measurement device with high input impedance, sensor output signals are not

changed by shortening the cable or splicing on additional cable in the field. Tests have shown that if the input

impedance of the measurements device is greater than 1 mega-ohm there is negligible effect on the calibration,

even after adding up to 100 m of cable. All Apogee sensors use shielded, twisted pair cable to minimize

electromagnetic interference. For best measurements, the shield wire must be connected to an earth ground. This

is particularly important when using the sensor with long lead lengths in electromagnetically noisy environments.

Modifying Cable Length

See Apogee webpage for details on how to extend sensor cable length:

(http://www.apogeeinstruments.com/how-to-make-a-weatherproof-cable-splice/).