Apogee Instruments SU-220 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Apogee Instruments SU-220에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Instruments SU-220 16 페이지. Ultraviolet-a sensor
Apogee Instruments SU-220에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지)
페이지 인쇄
CABLE CONNECTORS
Apogee started offering in-line cable connectors on
some bare-lead sensors in March 2018 to simplify the
process of removing sensors from weather stations for
calibration (the entire cable does not have to be
removed from the station and shipped with the sensor).
The ruggedized M8 connectors are rated IP68, made of
corrosion-resistant marine-grade stainless-steel, and
designed for extended use in harsh environmental
Inline cable connectors are installed 30 cm from the
conditions.
head
(pyranometer pictured)
Instructions
Pins and Wiring Colors: All Apogee connectors have six
pins, but not all pins are used for every sensor. There
may also be unused wire colors inside the cable. To
simplify datalogger connection, we remove the unused
pigtail lead colors at the datalogger end of the cable.
If you ever need a replacement cable, please contact us
directly to ensure ordering the proper pigtail
configuration.
A reference notch inside the connector ensures
Alignment: When reconnecting your sensor, arrows on
proper alignment before tightening.
the connector jacket and an aligning notch ensure
proper orientation.
Disconnection for extended periods: When
disconnecting the sensor for an extended period of time
from a station, protect the remaining half of the
When sending sensors in for calibration, only send the
connector still on the station from water and dirt with
short end of the cable and half the connector.
electrical tape or other method.
Tightening: Connectors are designed to be firmly
finger-tightened only. There is an O-ring inside the
connector that can be overly compressed if a wrench is
used. Pay attention to thread alignment to avoid cross-
Finger-tighten firmly
threading. When fully tightened, 1-2 threads may still
be visible.