Apogee Instruments SI Series 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Apogee Instruments SI Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Instruments SI Series 20 페이지. Infrared radiometer
페이지 인쇄
Temperature Measurement with Internal Thermistor
Measurement devices (e.g., datalogger, controller) do not measure resistance directly, but determine resistance
from a half-bridge measurement, where an excitation voltage is input across the thermistor and an output voltage
is measured across the bridge resistor.
An excitation voltage of 2.5 V DC is recommended to minimize self-heating and current drain, while still
maintaining adequate measurement sensitivity (mV output from thermistor per C). However, other excitation
voltages can be used. Decreasing the excitation voltage will decrease self-heating and current drain, but will also
decrease thermistor measurement sensitivity. Increasing the excitation voltage will increase thermistor
measurement sensitivity, but will also increase self-heating and current drain.
The internal thermistor provides a temperature reference for calculation of target temperature. Resistance of the
thermistor changes with temperature. Thermistor resistance (R
measurement, requiring an excitation voltage input (V
R
24900
T
V
where 24900 is the resistance of the bridge resistor in Ω. From resistance, temperature (T
with the Steinhart-Hart equation and thermistor specific coefficients:
T
K
A
B
ln(
R
where A = 1.129241 x 10
If desired, measured temperature in Kelvin can be converted to Celsius (T
T
T
273
.
15
C
K
NOTE: The wiring diagram below is based off the new wiring
colors for serial numbers 7283 and above.
V
EX
1
(1)
OUT
1
(2)
3
)
C
(ln(
R
))
T
T
-3
-4
, B = 2.341077 x 10
, and C = 8.775468 x 10
.
(3)
, in Ω) is measured with a half-bridge
T
) and a measurement of output voltage (V
EX
-8
(Steinhart-Hart coefficients).
):
C
):
OUT
, in Kelvin) is calculated
K