Apogee Instruments SP-230 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Apogee Instruments SP-230에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apogee Instruments SP-230 18 페이지. Pyranometer
Apogee Instruments SP-230에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)
페이지 인쇄
14
MAINTENANCE AND RECALIBRATION
Moisture or debris on the diffuser is a common cause of low readings. The sensor has a domed diffuser
and housing for improved self-cleaning from rainfall, but materials can accumulate on the diffuser (e.g.,
dust during periods of low rainfall, salt deposits from evaporation of sea spray or sprinkler irrigation
water) and partially block the optical path. Dust or organic deposits are best removed using water or
window cleaner and a soft cloth or cotton swab. Salt deposits should be dissolved with vinegar and
removed with a soft cloth or cotton swab. Never use an abrasive material or cleaner on the diffuser.
The Clear Sky Calculator (www.clearskycalculator.com) can be used to determine the need for
pyranometer recalibration. It determines total shortwave radiation incident on a horizontal surface at any
time of day at any location in the world. It is most accurate when used near solar noon in spring and
summer months, where accuracy over multiple clear and unpolluted days is estimated to be ± 4 % in all
climates and locations around the world. For best accuracy, the sky must be completely clear, as reflected
radiation from clouds causes incoming radiation to increase above the value predicted by the clear sky
calculator. Measured values of total shortwave radiation can exceed values predicted by the Clear Sky
Calculator due to reflection from thin, high clouds and edges of clouds, which enhances incoming
shortwave radiation. The influence of high clouds typically shows up as spikes above clear sky values, not
a constant offset greater than clear sky values.
To determine recalibration need, input site conditions into the calculator and compare total shortwave
radiation measurements to calculated values for a clear sky. If sensor shortwave radiation measurements
over multiple days near solar noon are consistently different than calculated values (by more than 6 %),
the sensor should be cleaned and re-leveled. If measurements are still different after a second test, email
to discuss test results and possible return of sensor(s).