4D systems gen4-uLCD-50 DCT 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} 4D systems gen4-uLCD-50 DCT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 4D systems gen4-uLCD-50 DCT 6 페이지. 5.0” slim intelligent display module with embedded diablo16 processor and resistive or capacitive touch panel

페이지 인쇄

QUICK START GUIDE

Power Up and Connect to a Computer Using gen4-IB & 4D Programming Cable

1) Connect one end of the FFC to your module's 30-way ZIF socket with the metal

contacts on the FFC facing up on the latch.

2) Connect the other end of the FFC to the 30-way ZIF socket on the gen4-IB* with the

metal contacts on the FFC facing up on the latch.

3) Connect the 5-Pin female header of the 4D Programming Cable to the gen4-IB

following the orientation on both cable and module labels. (you can also do this with

the assistance of the supplied ribbon cable)

4) Connect the other end of the 4D Programming Cable to the computer.

Power Up and Connect to a Computer Using gen4-IB & uUSB-PA5-II

1) Connect one end of the FFC to your module's 30-way ZIF socket with the metal

contacts on the FFC facing up on the latch.

2) Connect the other end of the FFC to the 30-way ZIF socket on the gen4-IB* with

metal contacts on the FFC facing up on the latch.

3) Connect the 5-Pin female header of the uUSB-PA5-II to the gen4-IB following the

orientation on both cable and module labels. (you can also do this with the

assistance of the supplied ribbon cable)

4) Connect a USB-Mini-B Cable to the uUSB-PA5-II.

5) Lastly, connect the other end of the uUSB-Mini-B to the computer.

Page 3 of 6