Dascom DP-510 운영자 매뉴얼 - 페이지 17

{카테고리_이름} Dascom DP-510에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dascom DP-510 19 페이지. Thermal printers
Dascom DP-510에 대해서도 마찬가지입니다: 빠른 설정 지침 (2 페이지)

WALL AND BELT MOUNTING INSTRUCTIONS

A combined bracket/clip suitable for attaching the printer to a wall or belt is available

The bracket snaps into the bottom of the printer, and when used to clip to a belt, it may be secured by using the

supplied extended screw (replaces the battery compartment screw). Prior to use, two small 'break-outs' must be

removed from the battery cover of the printer as shown below:

When attaching to a belt, the bracket should be put on the printer first, and then the entire assembly clipped over the

belt as shown:

The securing screw may be used if required.

When attaching to a wall, the bracket must be located on the wall using screws and wall plugs as shown. The printer

may then be clipped into place and removed as required.

Remove the two 'break-outs'

using a small screwdriver.

Use a finger or small screwdriver to

release the clip and then gently lift the

printer to remove from the wall bracket.