Apollo Discovery 45681-293 설치 매뉴얼 - 페이지 4

{카테고리_이름} Apollo Discovery 45681-293에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Apollo Discovery 45681-293 4 페이지. Sounder vad base
Apollo Discovery 45681-293에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지)

페이지 인쇄

XPERT Card Addressing

Select the desired address for the detector and remove the pips indicated in black. Remove

pips with a small screwdriver.

www.acornfiresecurity.com

Commissioning

It is important that the device be fully tested after installation. Many fault conditions are the

result of simple wiring errors. Check all connections to the unit.

Setup and Test Mode

These modes allow volume adjustment and functional testing locally. In test mode no

volume adjustment is possible.

The required mode is entered via the control panel and is con rmed by a red LED which

ashes once a second on the sounder VAD. Sounder state (on/off) is controlled by placing

a magnet adjacent to the ashing LED. When all LEDs ash, withdraw the magnet. A suit-

able extendable magnetic wand is available, part no. 29650-001.

In setup mode the volume can be adjusted by holding the magnet adjacent to the ash-

ing LED and removing it at the desired volume level. If min or max volume is reached, the

LEDs stop ashing. To alter the direction of adjustment, remove the magnet for one second

and re-apply. Saving the volume setting is performed at the control panel.

Coverage Diagram

Fig 2. Example of coverage pattern

The sides of the included rectangular coverage range from 3.06m X 6.28m to

5.06m X 5.06m

Coverage radius of a single VAD = 2.50m

Centre dark spot radius of a single VAD = 0.97m

Depth of section from the ceiling = 2.40m

Centre to centre spacing of VADs + 1.53m

For alternative mounting heights, please contact Apollo Fire Detectors Limited